What Do You Know About Systems

A Basic Guide in Misting or Fogging System Installation

It is vital that you have all the parts of a misting system in order for the installation to be done with ease and convenience.

Once all the parts have arrived in your place make sure you were able to inspect them properly, this way you can be assured that nothing is lost and there are no factory defect on it. Take a hard look with the manual and the ways by which all parts must be installed, this way you can expect the installation process to be smooth sailing. The pumping unit must be put together accurately and you must find a good power source in order for the machine to function along with water.

It is also vital that you are able to place the fogging system pumping unit in a place where it will not be susceptible to damage. The power source and the water supply must be near the fogging system unit so that it can operate more so this is another thing that you have to consider for its location.

Once the mainline is attached to the unit already, you have to start the next step of the installation. There are some that uses a flex hose and stainless steel for the mainline (this is the line that connects the misting unit to the area by which the nozzle line will be placed) If the nozzle line can only be installed using stainless steel suspension cables, these cables must be placed to both sides of the area that you want to be misted. At the end of one side, there must be a turnbuckle so that you are able to control the tightness of the cable more so for every 10 feet there must be a support cable that is installed so that everything will be leveled.

The zone valves must also be installed properly on the cable lines or on the solid surface. Afterwards, the installation of misting lines should be done. If you intend to use a misting system that is made from stainless steel then you must utilize a nozzle line that is 20 feet long.

Oftentimes brass fittings are used in misting systems to connect lines that are 20 feet long. For fogging systems that make use of brass fittings, rubber “O” rings are usually included in its parts. Water tight system is necessary in such misting systems that is why “O” rings must be placed on both sides. It is not also advisable to use a very tight union for the “O” ring might break down and penetrate the system. It is also vital to install a drain valve at the end of each nozzle line. Those are pretty much an overview of what misting and fogging installation is all about should you wish to know more you can just search for more info online.

Smart Ideas: Mists Revisited

Where To Start with Mists and More