Why People Think Installations Are A Good Idea

Your Ultimate Guide to Crown Molding and Pot Light Installation It is a challenge to do crown molding and pot lighting installation but with the right knowledge and skills, you will be able to do it with ease. How can you achieve a beautiful crown molding? In this article, we will be focusing on a project combining standard crown molding with two-pieces of mold base trim. It is a good idea measuring the length of the wall for the crown molding so you can buy pieces that are long enough to span each wall, and to prevent scarfing pieces together. If you plan using a light-colored stain, choose pieces with the same color or tone, and crown molding is usually installed with the use of handsaw, miter box, and hammer. You can choose to install your crown molding using a brad nailer and miter saw for better results and faster work. You can easily combine crown molding with other trim for a richer look. Built-up crown offers a lot of benefits such as eliminating nailing frustrations. In order for you to know where to drive the nails, you can use a chalk to put markings and lines, although professional carpenters put lines and marks right on the ceilings and wall, and just hide them with paint later on. Instead of marking your walls and ceilings, an easier method is using an easy-release masking tape with at least 2 inches wide. If you are planning to paint the ceiling and walls, you have to wait a couple of weeks before applying the tape, otherwise, it won’t stick well. Install the trim over the tape, leaving the tape in place for wall and ceiling protection when finish or paint the trim. For the crown molding trim placement, with the first piece in place, you just have to place the other pieces right next to it and working around the room following the same direction for the maximum utilization of the 45-degree cuts using a miter saw. You can use a construction adhesive on the rail to use just enough nails to hold the trim in proper position until the adhesive sets, with fewer nail holes to fill. The corners of your room may not be a perfect square, so you have to use test pieces in order to find the right angle for each corner, and you need to miter the ceiling rails inside and outside. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. It can be daunting and confusing having a DIY crown molding and pot installation project, so do not hesitate to contact a professional carpenter to help you. Check our moulding contractors review on our website now.The 10 Best Resources For Moulding

The 10 Best Resources For Moulding